Pre-installation Preparation
Tool and Site Preparation: Gather tools such as a jack, tire wrench, gloves, and wheel chocks; select a flat, solid surface and engage the parking brake to secure the vehicle.
Pre-loosening Lug Nuts: Loosen the lug nuts gradually in a diagonal pattern before lifting the vehicle; do not remove them completely at this stage.
Safe Vehicle Lifting: Position the jack at the vehicle's designated lifting point and slowly raise the vehicle until the tire clears the ground; remove all lug nuts and carefully take off the old tire.
Core Installation Operations
Cleaning the Hub Contact Surface: Clean mud, rust, and adhesive residue from old wheel weights off the hub surface to prevent vibration or abnormal noise during driving.
Positioning the New Tire: Align the off-road tire with the hub, ensuring the correct orientation (the side marked "Outside" or the side showing the manufacturing date should face outward), and push it firmly into place so it sits flush against the hub.
Initial Bolt Fastening:Thread all lug nuts into the holes by hand and tighten them slightly in a diagonal cross-pattern to prevent misalignment or uneven stress.
Proper Final Tightening: Slowly lower the jack until the tire rests fully on the ground, then use the wrench to tighten the lug nuts evenly in a diagonal sequence, applying torque according to the vehicle manufacturer's specifications.

